PRE-RELEASE
INSTALLATION
| INSTALLATION |
Before installing the rear oxygen (A/F) sensor, apply the anti-seize compound only to the threaded portion of the rear oxygen (A/F) sensor to make the next removal easier.
| Important | ||
|
Never apply anti-seize compound to protector of rear oxygen sensor. |
||
Anti-seize compound:
SS-30 by JET LUBE
Tightening torque:
21 Nm (2.1 kgf-m, 15.2 ft-lb)
Lower the vehicle.
Connect the connector to the rear oxygen sensor.
| Note | ||
|
Install the harness clip to bracket. |
Connect the battery ground cable to battery.
