SAAB WIS ONLINE

ASSEMBLY

ASSEMBLY

Clean all parts before assembly.

Mount the bushing and cushion rubber on the stay.


(A)

Bushing

(B)

Cushion rubber



Mount each part; boot, O-ring, bushing A, spacer, bushing B, bushing and spring pin on the gear shift lever.

Note
• Always use new O-rings.

• Apply grease [SUNLIGHT 2 (Part No. 32005009 or equivalent] to the inner and side surfaces of the bushing when installing the spacer.


(A)

Boot

(B)

O-ring

(C)

Bushing

(D)

Spacer

(E)

Bushing A

(F)

Bushing B

(G)

Spring pin

(H)

O-ring




Insert the gear shift lever into the boot hole.

Install the snap ring and stay to bushing B.


(A)

Snap ring

(B)

Bushing B

(C)

Stay



Tighten with lock wire to the extent that the boot will not come off.

Note

Always use new lock wire.



(A)

Lock wire

(B)

Stay



Insert the rod into the boot hole.

Connect rod to lever.

Tightening torque:

11.8 Nm (1.2 kgf-m, 8.7 ft-lb)


(A)

Rod

(B)

Lever

(C)

Stay



Check the swing torque of rod in relation to the gear shift lever.

Check that there is no excessive play and that parts move smoothly.