PRE-RELEASE
REMOVAL
| REMOVAL |
Set the vehicle on a lift.
Set the select lever to “N” range.
Disconnect negative cable from battery.
Lift-up the vehicle.
Remove front, center, rear exhaust pipe and muffler. (Saab 9-2X 2.5i Linear)
Remove the center and rear exhaust pipes and muffler. (Saab 9-2X 2.0T Aero)
Remove the heat shield cover. (If equipped)
|
(A)
|
Range select
lever
|
|
(B)
|
Snap pin
|
|
(C)
|
Select
cable
|
|
(D)
|
Clamp
|
|
(E)
|
Washer
|
Remove the plate assembly from transmission case.
|
(A)
|
Select
cable
|
|
(B)
|
Plate ASSY
|
|
(C)
|
Clamp
|
Disconnect the cable from select lever, and then remove the cable bracket.
|
(A)
|
Adjusting
nuts
|
|
(B)
|
Cable bracket
|
Remove the select cable from plate assembly.
