PRE-RELEASE
ASSEMBLY
| ASSEMBLY |
Assemble in the reverse order of disassembly.
Pulling up brush
Before assembling, press the brush down into brush holder, and then fix them in that position by passing a [1 mm (0.08 in) dia. 40 to 50 mm (1.6 to 2.0 in) long] wire through the hole as shown in the figure.
| Important | ||
|
Be sure to remove the wire after reassembly. |
||
|
(A)
|
Wire
|
Install the ball bearing.
Set the ball bearing on the front cover, and then securely install an appropriate tool (such as a fit socket wrench) to the bearing outer race.
Press the ball bearing into the specified position using a press.
Install the bearing retainer.
Press the bearing (rear side) into the rotor shaft using a press to install.
Heat the bearing box in rear cover [50 to 60°C (122 to 140°F)], and then press the rear bearing into rear cover.
| Important | ||
|
Grease should not be applied to rear bearing. Remove the oil completely if it is found on bearing box. |
||
After reassembly, turn the pulley by hand to check that rotor turns smoothly.
