PRE-RELEASE
OPERATION
| OPERATION |
When any on-board diagnostics item is malfunctioning, the display on AT OIL TEMP warning light blinks from the time malfunction is detected after starting the engine until ignition switch is turned to OFF. The malfunctioning part or unit can be determined by a DTC during on-board diagnostics operation. Problems which occurred previously can also be identified through the memory function. If the POWER indicator does not show a problem (although a problem is occurring), the problem can be determined by checking the performance characteristics of each sensor using Vehicle Diagnostic Interface. The indicator signal is as shown in the figure.
|
(1)
|
Ignition
switch (engine OFF)
|
(4)
|
Abnormal
(Trouble occurs)
|
(7)
|
Normal
(ATF temperature is high)
|
|
(2)
|
Normal
|
(5)
|
0.25 secs
|
(8)
|
ATF temperature
is high
|
|
(3)
|
2 secs
|
(6)
|
Blink
|
Execute the inspection if AT OIL TEMP warning light dies not operate normally.
