PRE-RELEASE
REMOVAL
| REMOVAL |
Set up the vehicle on a lift.
Disconnect the ground cable from battery.
Remove the air intake chamber. (Saab 9-2X 2.5i Linear)
Remove the intercooler. (Saab 9-2X 2.0T Aero)
Disconnect the transmission connector.
|
(A)
|
Transmission
connector
|
Remove the pitching stopper.
Remove the transmission connector from stay.
Lift-up the vehicle.
Clean the transmission exterior.
Drain the ATF completely.
| Note | ||
| • |
Tighten the ATF drain plug after draining the ATF.
|
|
| • |
Use a new gasket.
|
|
Tightening torque:
25 Nm (2.5 kgf-m, 18.1 ft-lb)
|
(A)
|
Oil pan
|
|
(B)
|
Drain plug
(ATF)
|
|
(C)
|
Differential
gear oil drain plug
|
Remove the front, center, exhaust pipes and muffler. (Saab 9-2X 2.5i Linear)
Remove the center, rear exhaust pipe and muffler. (Saab 9-2X 2.0T Aero)
Remove the shield cover. (If equipped)
Remove the propeller shaft.
Place the transmission jack under transmission.
| Note | ||
|
Make sure that the support plates of transmission jack don’t touch the crossmember. |
Remove the transmission rear crossmember bolts.
Lower the AT jack.
| Note | ||
|
Do not separate the AT jack and transmission. |
Remove the oil cooler inlet and outlet pipe.
| Note | ||
|
When removing the outlet pipe, be careful not to lose balls and springs used with retaining screws. |
Remove the front and torque converter turbine speed sensor.
|
(A)
|
Front vehicle
speed sensor
|
|
(B)
|
Torque
converter turbine speed sensor
|
Remove the rear vehicle speed sensor. (Saab 9-2X 2.0T Aero)
|
(A)
|
Rear vehicle
speed sensor
|
Disconnect the connector from rear vehicle speed sensor. (Saab 9-2X 2.5i Linear)
|
(A)
|
Rear vehicle
speed sensor
|
Remove the oil pan.
Remove the duty solenoids connector and ATF temperature sensor. Remove the connectors from clip and disconnect the connectors. (Saab 9-2X 2.0T Aero)
|
(A)
|
Lock-up
duty solenoid (Blue)
|
|
(B)
|
Low clutch
timing solenoid (Gray)
|
|
(C)
|
Line pressure
duty solenoid (Red)
|
|
(D)
|
Shift solenoid
2 (Yellow)
|
|
(E)
|
Shift solenoid
1 (Green)
|
|
(F)
|
2-4 brake
timing solenoid (Black)
|
|
(G)
|
2-4 brake
duty solenoid (Red)
|
|
(H)
|
ATF temperature
sensor
|
|
(I)
|
Transfer
duty solenoid (Brown)
|
|
(J)
|
Transmission
ground
|
Disconnect the harness connector and transmission ground terminal. (Saab 9-2X 2.5i Linear)
|
(A)
|
Transmission
ground
|
|
(B)
|
Harness
connector
|
Remove the harness assembly.
