INSTALLATION
| INSTALLATION |
| MPT MODEL |
Set the select lever to “P” range.
Using a plastic hammer, install reduction driven gear assembly and new washer, and tighten new drive pinion lock nut.
Tightening torque:
100 Nm (10.2 kgf-m, 73.8 ft-lb)
|
(A)
|
Reduction
driven gear
|
|
(B)
|
Reduction
drive gear
|
After tightening, stake the lock nut securely.
Combine the transmission case with the extension case, and install rear vehicle speed sensor.
Install the transmission assembly to vehicle.
| VTD MODEL |
Set the select lever to “P” range.
Using a plastic hammer, install reduction driven gear assembly.
Using a plastic hammer, install the center differential assembly.
Install a new self-lock nut and a washer.
Tightening torque:
100 Nm (10.2 kgf-m, 73.8 ft-lb)
After tightening, stake the lock nut securely.
Insert the rear drive shaft assembly.
Combine the transmission case with the extension case, and install rear vehicle speed sensor.
Install the transmission assembly to vehicle.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
