PRE-RELEASE
DISASSEMBLY
| DISASSEMBLY |
Place alignment marks on shaft and outer race.
| Important | ||
|
Be careful not to damage the boot. |
||
Remove the circlip from PTJ outer race using a screwdriver.
Remove the PTJ outer race from shaft assembly.
Wipe off the grease.
| Important | ||
|
The grease is a special grease. Do not confuse with other greases. |
||
Place alignment marks on free ring and trunnion.
Remove the free ring from trunnion.
| Important | ||
|
Be careful with the free ring position. |
||
Place an alignment mark on trunnion and shaft.
Remove the snap ring and trunnion.
| Important | ||
|
Be sure to wrap the shaft splines with vinyl tape to prevent the boot from scratches. |
||
Remove the PTJ boot.
Place the drive shaft in a vise between wooden blocks.
| Important | ||
|
Do not place the drive shaft directly in a vise; use wooden block. |
||
Raise the boot band claws by means of screwdriver and hammer.
|
(A)
|
Boot band
claws
|
Cut and remove the boot.
| Important | ||
|
The boot must be replaced with a new one whenever it is removed. |
||
| Note | ||
|
Further disassembly of axle is impossible because the EBJ cannot be disassembled. |
