PRE-RELEASE
ASSEMBLY
| ASSEMBLY |
| Note | ||
|
When the hub is to be removed from housing, replace the bearing set and oil seal with new ones. |
Using the ST, press the new hub bolt into place.
| Note | ||
| • |
Ensure the hub bolt closely
contacts the hub.
|
|
| • |
Use a 12 mm (0.47 in) hole in the ST to prevent the
hub bolt from tilting during installation.
|
|
ST 32005200 HUB STAND
| Note | ||
| • |
Ensure the tone wheel closely contacts the hub.
|
|
| • |
Be careful not to damage the tone wheel teeth.
|
|
|
(1)
|
Tone wheel
|
Clean the housing interior completely. Using the ST1 and ST2, press the bearing into housing.
ST1 32005209 HOUSING STAND
ST2 32005210 BEARING REMOVER
| Note | ||
|
Be careful not to remove the plastic lock from inner race when installing the bearing. |
Using pliers, install the snap ring firmly.
|
(1)
|
Pliers
|
Using the ST1 and ST2, press the outer oil seal until it comes in contact with snap ring.
ST1 32005209 HOUSING STAND
ST2 32005212 OIL SEAL INSTALLER
|
(1)
|
Snap ring
|
Invert both ST1 and housing.
Using the ST2, press the inner oil seal into housing until it touches the bottom.
ST1 32005209 HOUSING STAND
ST2 32005212 OIL SEAL INSTALLER
Using the ST1 and ST2, press the sub seal into place.
ST1 32005209 HOUSING STAND
ST2 32005212 OIL SEAL INSTALLER
Apply sufficient grease to oil seal lip.
Specified grease:
SHELL 6459N
| Note | ||
| • |
If specified grease is not available, remove the bearing
grease and apply Auto Rex A instead.
|
|
| • |
Do not mix different types of grease.
|
|
Install the back plate to rear housing.
Tightening torque:
52 Nm (5.3 kgf-m, 38.3 ft-lb)
Using the ST1 and ST2, press the bearing into hub.
ST1 32005200 HUB STAND
ST2 32005211 HUB INSTALLER
|
(1)
|
Back plate
|
