PRE-RELEASE
DISASSEMBLY
| DISASSEMBLY |
Using the ST1 and ST2, remove the hub from rear housing.
ST1 32005200 HUB STAND
ST2 32005208 HUB REMOVER
Using a standard screwdriver, remove the outer and inner oil seals.
Using a flat tip screwdriver, remove the snap ring.
| Note | ||
|
Be careful not to damage the housing at removal. |
Using the ST1 and ST2, remove the bearing by pressing the inner race.
ST1 32005209 HOUSING STAND
ST2 32005210 BEARING REMOVER
Remove the tone wheel bolts, and then remove the tone wheel from hub.
Using the ST, press the hub bolt out.
ST 32005200 HUB STAND
| Important | ||
|
Be careful not to hammer the hub bolts. This may deform the hub. |
||
