SAAB WIS ONLINE

DISASSEMBLY

DISASSEMBLY

Straighten the bent claw of larger end of DOJ boot.

Loosen the band by means of screwdriver or pliers with care of not damaging boot.


Remove the boot band on the small end of DOJ boot in the same manner.

Remove the larger end of DOJ boot from DOJ outer race.

Pry and remove the round circlip located at neck of DOJ outer race with a screwdriver.


Take out the DOJ outer race from shaft assembly.

Wipe off the grease, and then take out the balls.

Note
• The grease is a special grease (grease for constant velocity joint). Do not confuse with other greases.

• Disassemble with exercising care not to lose balls (6 pcs).



(A)

Outer race

(B)

Grease



To remove the cage from inner race, turn the cage by a half pitch to the track groove of inner race, and shift the cage.

Remove the snap ring, which fixes the inner race to shaft, by using pliers.

Take out the DOJ inner race.

Take off the DOJ cage from shaft and remove the DOJ boot.

Wrap the shaft splines with vinyl tape.

Remove the BJ or EBJ boot in the same procedure as DOJ boot.

Note

Further disassembly of axle is impossible because the BJ and EBJ cannot be disassembled.