REPLACEMENT

REPLACEMENT

Clean the transmission exterior.

Drain the gear oil completely.

Note
Tighten the drain plug after draining gear oil.

Tightening torque:

69 Nm (7.0 kgf-m, 50.6 ft-lb)

Remove the rear exhaust pipe and muffler.

Remove the heat shield cover. (If equipped)

Remove the propeller shaft.

Using the ST, remove the oil seal.

ST 32005071 PULLER ASSY

(A)

Oil seal

Using the ST, install the oil seal.

ST 32005087 INSTALLER

Install the propeller shaft.

Install the heat shield cover. (If equipped)

Install the rear exhaust pipe and muffler.

Pour gear oil and check the oil level.