PRE-RELEASE
INSPECTION
| INSPECTION |
CHECK Vehicle Diagnostic Interface.
Do you have a Vehicle Diagnostic Interface?
| Yes |
| No |
CHECK G SENSOR.
Turn the ignition switch to OFF.Remove the G sensor from vehicle.
Connect the connector to G sensor.
Turn the ignition switch to ON.
Measure the voltage between G sensor connector terminals.
Connector & terminal
(B292) No. 2 (+) — No. 3 (−):
Is the voltage 2.3±0.2 V when G sensor is horizontal?
| Yes |
| No |
Replace the G sensor.
CHECK G SENSOR.
Measure the voltage between G sensor connector terminals.Connector & terminal
(B292) No. 2 (+) — No. 3 (−):
Is the voltage 3.9±0.2 V when G sensor is inclined forwards to 90°?
| Yes |
| No |
Replace the G sensor.
CHECK G SENSOR.
Measure the voltage between G sensor connector terminals.Connector & terminal
(B292) No. 2 (+) — No. 3 (−):
Is the voltage 0.7±0.2 V when G sensor is inclined backwards to 90°?
| Yes |
G sensor is normal.
| No |
Replace the G sensor.
CHECK G SENSOR.
Turn the ignition switch to OFF.Connect the Vehicle Diagnostic Interface to data link connector.
Turn the Vehicle Diagnostic Interface into {BRAKE CONTROL} mode.
Set the display in the {Current Data Display & Save} mode.
Read the G sensor output voltage.
Is the indicated reading 2.3±0.2 V when the vehicle is in horizontal position?
| Yes |
| No |
Replace the G sensor.
CHECK G SENSOR.
Remove the console box.Remove the G sensor from vehicle. (Do not disconnect the connector.)
Read the Vehicle Diagnostic Interface display.
Is the indicated reading 3.9±0.2 V when G sensor is inclined forwards to 90°?
| Yes |
| No |
Replace the G sensor.
CHECK G SENSOR.
Read the Vehicle Diagnostic Interface display.Is the indicated reading 0.7±0.2 V when G sensor is inclined backwards to 90°?
| Yes |
G sensor is normal.
| No |
Replace the G sensor.
