PRE-RELEASE
INSPECTION
| INSPECTION |
Check bearing axial end play and hub runout before disc rotor runout limit inspection.
Secure the disc rotor by tightening five wheel nuts.
Set a dial gauge 10 mm (0.39 in) inward of rotor outer perimeter. Turn the disc rotor to check runout. If the disc rotor runout is above specified value, replace the disc rotor.
0.070 mm (0.0027 in)
Set a micrometer 10 mm (0.39 in) inward of the rotor outer perimeter, and then measure the disc rotor thickness. If the thickness of disc rotor is outside the service limit, replace the disc rotor.
|
Standard value
|
Service limit
|
Disc
outer dia.
|
||
|
Disc
rotor thickness A
|
14″
|
10
mm
(0.39 in) |
8.5
mm
(0.335 in) |
266
mm
(10.47 in) |
