PRE-RELEASE
REMOVAL
| REMOVAL |
Pull down and release the parking brake.
Remove the two mounting bolts and remove the brake caliper assembly.
|
(1)
|
Brake caliper
assembly
|
Suspend the brake caliper assembly so that the hose is not stretched.
Remove the disc rotor.
| Note | ||
|
If the disc rotor is difficult to remove, try the two following methods in order. |
Turn the adjusting screw using a flat tip screwdriver until brake shoe gets away enough from the disc rotor.
|
(1)
|
Adjusting
screw
|
|
(2)
|
Adjusting
hole cover (rubber)
|
|
(3)
|
Flat tip
screwdriver
|
|
(4)
|
Back plate
|
If the disc rotor seizes up within hub, drive the disc rotor out by installing two 8-mm bolts in holes B on rotor.
Remove the shoe return spring from parking brake assembly.
Remove the front shoe hold-down spring and pin with pliers.
Remove the strut and strut spring.
Remove the adjuster assembly from parking brake assembly.
Remove the brake shoe.
Remove the rear shoe hold-down spring and pin with pliers.
Remove the parking brake cable from parking brake lever.
|
(1)
|
Parking
brake cable
|
|
(2)
|
Parking
brake lever
|
Using a standard screwdriver, raise the retainer. Remove the parking brake lever and washer from brake shoe.
