SAAB WIS ONLINE

DISPOSAL

DISPOSAL

REAR GATE DAMPER STAY

Important

Gas is colorless, odorless, and harmless. However, gas pressure may spray the cutting powder or oil. Be sure to wear dust-resistant goggles.


Cover with a vinyl case as shown in the figure.


(1)

Rear gate damper stay

(2)

Vinyl sack



Note

Prevent the vinyl case from being caught by drill cutting edge


Lift the body side slightly with piston rods fully extended, and secure the body side on vise stand.

Drill a hole in 2 to 3 mm (0.08 to 0.12 in) diameter at a point 10 to 200 mm (0.39 to 7.87 in) from door side, and bleed the rear gate damper stay completely.


(1)

Body side

(2)

Door side

(3)

190 mm (7.48 in)

(4)

10 mm (0.39 in)

(5)

Piston rod

(6)

Cylinder

(7)

Portion to be drilled