INSTALLATION
| INSTALLATION |
Apply adhesive in the same procedure as for windshield glass.
Insert the glass locating pin into the rear gate hole, and after pushing on the area around the locating pin to secure it, push lightly all around the area to seal it.
About one hour after installation, conduct a water leak test.
|
(1)
|
Upper side
|
|
(2)
|
Molding
|
|
(3)
|
Glass
|
|
(4)
|
Adhesive
|
|
(5)
|
Lower side
|
|
(6)
|
Glass
|
|
(7)
|
Molding
|
|
(8)
|
Adhesive
|
After completion of all work, allow the vehicle to stand for about 24 hours.
| Note | ||
| • |
When the door is opened/closed after glass
is bonded, always lower the door glass and then open/close
it carefully.
|
|
| • |
Move the vehicle slowly.
|
|
| • |
For minimum drying time and time the vehicle must be
left standing before driving after bonding, follow the instructions
or instruction manual from adhesive manufacturer.
|
|
| • |
When a vehicle is returned to the user, tell him or her
that the vehicle should not be subjected to heavy impact for at
least three days.
|
|
Connect the rear defogger terminals.
Install the rear wiper.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
