PRE-RELEASE
B1830
Read the instructions below then start the fault diagnostic procedure.
Symptom: Internal fault in relay.
| B1830 |
Fault symptom
Internal fault in relay.Condition
Control module cannot receive a response from the relay in question.Diagnostic procedure
There is communication on the VR-bus as long as there is +54 current. This DTC is generated if response is missing from the relay in question.The cause of the problem could be power supply, grounding or that bus connection is missing.
| - |
Try moving the relay to the position for the left rear window.
|
|
| - |
Activate the relay with the button for left front window on the centre console.
|
|
| - |
Left rear window should raise or lower.
|
|
| - |
If the left rear window raises or lowers, the problem is most likely in the wiring harness
|
|
Checking wiring harness
Intermittent faults can exist during temporary short circuits and open circuits. Wiggle the wiring harness at several points and in different directions to discover problems in the wiring harness and connectors. Observe the multimeter, diagnostic tool or the test lamp during checking.
