PRE-RELEASE
Front doors
| Front doors |
| To remove |
| 1. |
Unplug the wiring harness connector in the door (bayonet fitting).
|
|
| 2. |
Remove the door stop from the A-pillar.
|
|
| 3. |
Remove the hinge bolts.
|
||||||||||
| To fit |
Fit in reverse order.
Tightening torque:
Hinge bolts: 47 Nm (35 lbf ft).
| Note | ||
|
On order to get the correct fit between the door and wing, it may be necessary to lift slightly at the rear edge of the door. This applies especially to the 3-D model. |
Connect the diagnostics tool and erase any diagnostic trouble code.
| Adjustment |
Adjust the door, se Adjustment of front and rear doors
