PRE-RELEASE
Replacement of upper door seal, front
| Replacement of upper door seal, front |
| Replacement |
There are two different procedures, A and B, depending on the model year and VIN.
A Weather seal fastened with butyl tape in B-pillar trim radius
| 1. |
Open the door and remove the scuff plate and door weather seal.
|
|
| 2. |
Remove any remains of the butyl tape from the B-pillar trim.
|
|
| 3. |
Fit the new weather seal. Start in the top rear corner with the colour marking in the centre of the radius.
Fit the rest of the seal. |
|
| 4. |
Wash off the colour marking with water.
|
|
B Weather seal fastened with plastic plug in B-pillar trim radius
| 1. |
Open the door and remove the scuff plate.
|
|
| 2. |
Remove the plastic plug securing the door weather seal to the top rear corner of the B-pillar trim and remove the door weather seal.
|
|
| 3. |
Position the new weather seal with the colour marking towards the roof just where the radius starts.
|
|
| 4. |
Make a 5 mm hole, 8 mm in from the edge of the lip, to correspond with the hole in the B-pillar trim.
|
|
| 5. |
Fit the plastic plug.
|
|
| 6. |
Fit the rest of the seal.
|
|
| 7. |
Wash off the colour marking with water.
|
|
| 8. |
Fit the sill scuff plate.
|
|
