PRE-RELEASE
Window lift, rear door
| Window lift, rear door |
| To remove |
| 1. |
Remove the door trim, see Service Manual, 8:2 Interior Equipment.
|
|
| 2. |
Remove the plastic water barrier.
|
|
| 3. |
Remove the external window seal by first releasing the clip at the rear with suitable pliers and pull it out by hand, there is also a clip at the front edge.
|
|
| 4. |
Loosen the retainer screw for the rear guide channel.
|
|
| 5. |
Run down the window glass approximately 10 cm so that the window mount is visible in the upper holes on the inside of the door.
|
|
| 6. |
Fasten the glass on top of the frame with tape, use 2 strips of tape.
|
|
| 7. |
Unplug the connector for the window lift motor.
|
|
| 8. |
Drill out the blind-rivet heads (5 pcs, 8.5 mm drill bit).
|
|
| 9. |
Knock the rivets out of the door (4 mm drift). Hold the window lift.
|
|
| 10. |
Guide out the window lift with motor from the window mount by pulling it rearwards in the door, fold it down and lift it out of the door.
|
||||||||||
| To fit |
Fit in reverse order.
| Note | ||
|
The work is facilitated by using heavy pop-rivet pliers. |
