PRE-RELEASE
Windscreen seal, CV
| Windscreen seal, CV |
| To remove |
| 1. |
Remove the plugs from the windscreen frame seal.
|
|
| 2. |
Remove the bolts and remove the seal from the windscreen frame.
|
|
| To fit |
| 1. |
Start to fit from each corner.
|
|
| 2. |
Tighten down the seal.
|
|
| 3. |
Fit the plugs.
|
|
| 4. |
Pull off the protective backing from the double-backed tape and start to fit the seal at the bottom of the A-pillar and continue upwards to the corner.
|
|
| 5. |
Continue fitting from the centre at the top of the windscreen and out towards the edges. Use soapy water to facilitate fitting.
|
|
| 6. |
Check the fit against the front seal. If necessary adjust the front seal. See
Adjusting seals
.
|
|
