PRE-RELEASE
Procedure before replacing the turbo
| Procedure before replacing the turbo |
| To remove |
| 1. |
Raise the car, place a receptacle under the car and drain the oil through the drain plug on the oil sump. Fit the drain plug.
|
|
| 2. |
Lower the car and fill with oil to the MAX marking. The distance between the markings correspond to a volume of 1 litre (1.05 qt).
|
|
| 3. |
Start the engine and run it at idle speed until the thermostat has opened (radiator fan starts).
|
|
| 4. |
Raise the car and drain the oil. Fit the drain plug.
Tightening torque 25 Nm (19 lbf ft) |
|
| 5. |
Lower the car and remove the upper engine cover.
|
|
| 6. |
Unplug the EGR-valve connector.
|
|
| 7. |
Take off the lid on the oil filter housing and remove the oil filter.
|
|||||||
| 8. |
Change the O-rings.
|
|
| 9. |
Fit a new oil filter and tighten the lid on the oil filter housing.
Tightening torque 25 Nm (18 lbf ft) 
|
|
| 10. |
Plug in the EGR-valve connector.
|
|
| 11. |
Top up engine oil according to specifications, see
Lubricating system
|
|
| 12. |
Start the engine and let it run until the oil pressure warning lamp goes out. Stop the engine and check the oil level. Top up if necessary.
|
|
