PRE-RELEASE
Work on a car equipped with the SRS
| Work on a car equipped with the SRS |
| Welding |
Disconnect the battery's negative cable and cover it before starting any welding work.
| Painting |
Before painting, cover the ground connections and weld bolts in the SRS control module retaining bracket with masking tape to ensure the integrity of the control module's ground connection.
| Electrical work |
Electric cables in the airbag system must not be spliced. Splicing can be the cause of system malfunctions which could result in injury or render the system unserviceable.
| Fault diagnosis |
For handling instructions, see
.
| Work on the car body |
If work on the car body involves hammering and other impacts, the ignition switch must be in the OFF position.
| Work on the steering gear |
If any work is carried out when the contact roller is fitted and the steering column shaft is not connected to the steering gear, the steering wheel must be locked in position so that the basic setting of the contact roller will not be altered.
|
|||||||
Warning
| Scrapping and recycling |
For scrapping and recycling the car, see Service Manual 8:7.
| In connection with the repair of crashed cars |
When repairing crashed cars it is important to ensure that the right components are inspected and changed as necessary to avoid any doubts as to the car's reliability after the repair. For further information on repairing crashed cars and replacing components on them, see
.
