PRE-RELEASE
Swivel cable, soft top cover access flaps
| Swivel cable, soft top cover access flaps |
| Removing |
| 1. |
Raise the soft top cover and remove the covering shell.
|
|
| 2. |
Mark the position for the bolts securing the soft top cover latch.
|
|
| 3. |
Remove the bolts and lift away the latch.
|
|
| 4. |
Remove the bolts securing the access flap.
|
|
| 5. |
Release the clip securing the cable and pull the cable out of the access flap and the casing.
|
|
| 6. |
Remove the operating arm holder with cable.
|
|
| 7. |
Unplug the connector and remove the microswitch. Transfer the microswitch to the new operating arm holder.
|
|
| Fitting |
| 1. |
Fit the operating arm holder with cable.
|
|
| 2. |
Fit the microswitch on the operating arm holder.
|
|
| 3. |
Insert the cable in the casing and fit it in the access flap. Make sure that the access flap is in the same upright position as when removing. Fit the clip on the cable casing.
|
|
| 4. |
Refit the access flap and tighten the bolts.
|
||||||||||
| 5. |
Fit the latch and tighten according to markings. Fit the clip.
|
|
| 6. |
Adjust the access flaps with the bolt so that they are flush with the soft top cover.
|
|
