SAAB WIS ONLINE

PRE-RELEASE

30 07 655 Gasket remover No 4

30 07 655 Gasket remover No 4


Specifications

Loctite. Dissolves burnt on gaskets and oils, gasket adhesives and carbonised residue, etc. No exterior damage. Spray 300 ml.

Saab application

See Service Manual.

Packaging

1

Transport

The product is classified as dangerous goods when transporting. Special regulations apply to packaging, marking and transport, therefore existing lead times cannot be guaranteed.

Directives

The product is highly flammable. Pressurized can. Must not be exposed to direct sunlight or temperatures above +50 ° C. Must not be punctured or burned. Also applies to empty can. Do not spray toward open flame or glowing materials. Must be stored separately from materials which may ignite the product - Smoking is prohibited. Avoid inhaling spray mist. Make sure that ventilation is adequate.

Material safety data sheet


1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND THE COMPANY/UNDERTAKING

Product code

128535a

Product name

7200

Manufacturer - supplier

Loctite Sweden AB

Box 8823

SE-402 71 GÖTEBORG

Tel: +46 31 7505400

Fax: +46 31 7505391

Tel (emergencies): +353-1-4599301 / +353-87-2629625 / +353-1-4046444



2. COMPOSITION/INFORMATION ON INGREDIENTS

Product type

Solvent-based gasket remover



Ingredient

CAS-no.

Conc (%)

R-phrases

Classification

Propane

74-98-6

5.00 - 15.00

R12

F+

Dimethoxymethane

109-87-5

30.00 - 60.00

R11

F

1,3-dioxolane

646-06-0

5.00 - 15.00

R7, R21/22, R23, R34, R48/20/22, R51/53

O, T, N

Ethanolamine

141-43-5

1.00 - 5.00

R20, R36/37/38

Xn

Methyl ethyl ketone

78-93-3

1.00 - 5.00

R11, R36/37, R320, R322, R313

F, Xi

Ethanol

64-17-5

5.00 - 15.00

R11

Isopropanol

67-63-0

5.00 - 10.00

R11, R320, R322, R313

F, V



Key

FB/FH/FM = Hazard code for fire/health/environment

T+ = Very toxic

T = Toxic

C = Corrosive

Xn = Harmful

Xi = Irritant

V = Moderately harmful

IK = Not subject to labelling

E = Explosive

O = Oxidizing

F+ = Extremely flammable

F = Highly flammable

N = Dangerous for the environment



3. HAZARDS IDENTIFICATION

Extremely flammable. Do not expose pressurized container to high temperatures.

Adverse health effects

Solvent will have a defatting action on the skin which may cause cracking and, on repeated contact, eczema. Inhalation of vapours may cause headaches or nausea.



4. FIRST AID MEASURES

Inhalation

Move to fresh air. If symptoms persist, seek medical advice.

Skin

Remove contaminated clothing and wash immediately with plenty of soap and water.

Eyes

Rinse immediately with plenty of water for at least 15 minutes. If irritation persists, seek medical attention.

Ingestion

Rinse mouth with water then give plenty of water to drink. Do not induce vomiting. Seek medical advice.



5. FIRE-FIGHTING MEASURES

Suitable extinguishing media

This product is extremely flammable. If product is involved in fire extinguish with dry powder, foam or carbon dioxide.

Fire/Explosions risks

Aerosol containers may explode when exposed to high temperatures.

Special protective equipment for firefighters

Protective clothing should be worn when dealing with fire.



6. SPILLAGE/ACCIDENTAL RELEASE MEASURES

Personal precautions

Wear protective clothing and suitable respiratory protection. Ventilate area.

Methods for cleaning up

Try to prevent the material from entering drains or water courses. Contain spillage, and absorb onto an inert absorbent such as sand or multisorb and place in a sealed container for supervised disposal.



7. HANDLING AND STORAGE

Advice for safe handling

Use in a well ventilated area. Wear suitable protective clothing, safety glasses and gloves. Keep away from sources of ignition - no smoking.

Storage instructions

Keep away from sources of ignition. No smoking. Store away from heat in a cool, well-ventilated area.



8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Chemical identity

Limit

Dimethoxymethane

ACGIH: TLV 1000ppm 8 t. TWA.

Methyl ethyl ketone

SE: NGV 50ppm 8h TWA. SE: KTV 100ppm (300mg/m3) 15min.

Ethanol

SE: NGV 500ppm 8h TWA. SE: KTV 1000ppm (1900mg/m3) 15min.

Isopropanol

SE: NGV 150ppm 8h TWA. SE: KTV 250ppm (600mg/m3) 15min.



Hand protection

In case of repeated or prolonged skin contact, wear suitable gloves made of PVC, polyethene, natural rubber or similar ester-resistant material.



9. PHYSICAL AND CHEMICAL PROPERTIES

Form/state

Liquid

Odour

Alcoholic

Colour

Amber

pH

10.6-11.0 at 20°C

Solubility in water

Insoluble

Solubility in acetone

Miscible

Density

0.808 g/cm 3 at 20°C

Explosion limits

0.6 vol% to 23.0 vol%

Vapour pressure

3.4 bar at 20°C



10. STABILITY AND REACTIVITY

Stability

Relatively stable under recommended conditions of storage and handling.

Avoid

Avoid contact with strong acids and oxidizing agents. Avoid elevated temperatures.



11. TOXICOLOGICAL INFORMATION

Inhalation

Inhalation of vapours may cause headaches or dizziness. Exposure to the solvent vapour should be minimized and the product should be used where adequate ventilation is available.

Skin

Solvent may remove essential oils from the skin making it susceptible to attack from other chemicals.

Eyes

Vapours may be irritating to eyes causing lachrymatory effect.

Ingestion

Ingestion of large quantities may cause liver or kidney damage.



12. ECOLOGICAL INFORMATION

Storage

Keep away from water and drains.



13. DISPOSAL CONSIDERATIONS

Disposal considerations

Dispose of in accordance with local and national regulations. Incinerate or dispose of in accordance with local and national regulations.



14. TRANSPORT INFORMATION

UN-no.

1950

Air (IATA)

Aerosols, flammable, n.o.s., Class 2.1, flammable gas.

Sea (IMO)

Aerosol, Class 2.1 EmS 2-13 MFAG 4.2.

Road/Rail (ADR/RID)

Gas, compressed, Class 2, Item no. 5° F (Aerosol).



15. REGULATORY INFORMATION

Hazard class/Symbol

Extremely flammable



R-phrases

R12

Extremely flammable.

R313

May defat the skin.

S-phases

S2

Keep out of the reach of children. S16

S16

Keep away from sources of ignition - No smoking.

S23

Do not breathe vapours.

S24/25

Avoid contact with skin and eyes.

S51

Use only in well-ventilated areas.

Other information

Pressurized container: protect from sunlight and do not expose to temperatures exceeding +50°C. Do not pierce or burn, even after use. Do not spray on a naked flame or any incandescent material.



16. OTHER INFORMATION

This material safety data sheet was prepared in accordance with Commission Directive (88/379/EES and 91/155/EEC) and other relevant directives and ordinances. This material safety data sheet provides information on the safe handling and use of the product.

The information in this material safety data sheet was obtained from reputable sources and to the best of our knowledge is accurate and current at the mentioned date. Neither Loctite nor its subsidiary companies accept any liability arising out of the use of the information provided here or the use, application or processing of the product(s) described herein. Attention of users is drawn to the possible hazards from improper use of the product(s). Superseding material safety data sheet no.: 3.0 dated 06/10/98.

Material safety data sheet revised

1999-03-22

For more information

Loctite Corporation, International Health and Regulatory Affairs, Tallaght Business Park, Whitestown, Dublin 24, Ireland.

Tel: +353-1-4046444

Fax: +353-1-4510806

Produced by

Caroline Walsh MSc HRA Specialist Health & Regulatory Affairs - Europe




PRE-RELEASE