PRE-RELEASE
Oil pump
| Oil pump |
| 1. |
Detach the air cleaner and put it to one side.
|
|
| 2. |
Relieve the pressure on the belt tensioner using a ratchet handle extension and insert a 6 mm drill into the hole.
|
||||||||||
| 3. |
Raise the car, remove the front right wheel and remove the cover. Lift off the drive belt from the crankshaft belt pulley.
|
|
| 4. |
Remove the crankshaft pulley and the oil pump's circlip. Lift off the pump cover using a large pair of slip-joint pliers. Remove the pump gears.
|
|
| To fit (in car) |
| 1. |
Make sure the marking on the oil pump ring gear is facing outwards and check the position and condition of the O-ring.
|
|
| 2. |
Fit the pump gears and position the pump cover with the aid of the locating arrows.
|
|
| 3. |
Fit the circlip with the chamfer facing outwards and the opening downwards.
|
|
| 4. |
Fit the crankshaft pulley.
Tightening torque: 175 Nm (129.5 lbf ft) |
|
| 5. |
Fit the drive belt and check its position on all the belt pulleys.
|
|
| 6. |
Fit the cover and wheel.
Tightening torques: Wheels: 120 Nm (89 lbf ft) |
|
| 7. |
Lower the car. Relieve the pressure on the belt tensioner with a ratchet handle extension and remove the drill.
|
|
| 8. |
Fit the air cleaner.
|
|
| 9. |
Start the engine and run it at idling speed for a while.
|
|
| 10. |
Switch off the engine and check that the belt is correctly positioned.
|
|
