PRE-RELEASE
Throttle cable
| Throttle cable |
| 1. |
Remove the cover from the accelerator position sensor and unhook the throttle cable from the cam.
|
|
| 2. |
Cut away the fasteners securing the throttle cable.
|
|
| 3. |
Remove the bottom of the dashboard and unhook the throttle cable from the accelerator.
|
|
| 4. |
Make a note of and remove the throttle cable fastener, and unto the clip.
|
|
| 5. |
Hold on to the plastic sleeve and pull the throttle cable through the bulkhead out into the engine compartment.
|
|
| To fit |
| 1. |
Insert the wire through the bulkhead.
|
||||||||||
| 2. |
Hook the throttle cable onto the accelerator.
|
||||||||||
| 3. |
Hook the throttle cable onto the cam and fit the clip.
|
|
| 4. |
Secure the cable and adjust it by turning the adjusting screw until the position sensor cam begins to move. Then turn back the adjusting screw one half turn.
|
|
| 5. |
Refit the cover over the accelerator position sensor.
|
|
| 6. |
Fit the bottom lower section of the dashboard.
|
|
