PRE-RELEASE
Ball joint (bellows)
| Ball joint (bellows) |
| 1. |
Remove the nut to the anti-roll bar.
|
|
| 2. |
Loosen the nut to the ball joint. Use puller 89 96 696 to press out the bolt from the swivel member.
|
|
| 3. |
Remove the ball joint nut and pull down the stanchion/suspension arm.
|
|
| 4. |
Remove the lock ring securing the bellows and take off the bellows.
|
|
| To fit |
| 1. |
Fill the new bellows with Molycote Longterm 2-78 grease.
|
|
| 2. |
Fit the bellows and lock ring.
|
|
| 3. |
Press up the stanchion/suspension arm into the correct position and fit the ball joint nut. Tighten the nut.
Tightening torque: 75 Nm (55 lbf ft). |
|
| 4. |
Fit the anti-roll bar nut and tighten it.
Tightening torque: 10 Nm (7.4 lbf ft). |
|
