PRE-RELEASE
Track-rod ends
| Track-rod ends |
| 1. |
Slightly loosen the clamp bolt.
|
|
| 2. |
Slightly loosen the nut.
|
|
| 3. |
Use puller 89 96 696 to press out the track-rod end.
|
|
| 4. |
Remove the nut.
|
|
| 5. |
Measure the length of thread on the adjuster screw.
|
|
| 6. |
Unscrew the track-rod end (use an adjustable spanner to steady the track rod).
|
|
| To fit |
| 1. |
Screw on the track-rod end to the correct position on the adjusting screw thread.
|
||||||||||
| 2. |
Fit the track-rod end to the steering swivel member and tighten it.
Tightening torque: 60 Nm (44 lbf ft). |
|
| 3. |
Tighten the clamp bolt.
Tightening torque: 22 Nm (16 lbf ft). |
|
| 4. |
Check the toe-in and adjust as necessary. See
.
|
|
