PRE-RELEASE
Wing liners
| Wing liners |
| Removing |
| 1. |
Raise the car and remove the front wheel.
|
|
| 2. |
Remove the mudflap by removing 1 the plastic nut and 3 screws in the wheel housing.
|
|
| 3. |
Remove the wing liner's 3 retaining screws and 3 plastic rivets in the wheel housing.
|
|||||||
| 4. |
Remove the retaining screw that secures the front end of the wing liner to the air shield and the retaining screw that secures the wing liner to the bumper.
|
|
| 5. |
Release the wing liner clasp from the front wing using a screwdriver and remove the wing liner from the wheel housing.
|
||||||||||
| Fitting |
| 1. |
Fit the wing liner to the front wing by pressing the clasps back into place.
|
|
| 2. |
Fit the retaining screw that secures the front end of the wing liner to the air shield and the retaining screw that secures the wing liner to the bumper.
|
|
| 3. |
Fit the wing liner's 3 retaining screws and 3 plastic rivets in the wheel housing.
|
|
| 4. |
Fit the plastic mudflap nuts and 3 screws.
|
|
| 5. |
Fit the front wheel and lower the car.
|
|
Saab 9-3 Viggen:
Use nuts, part no. 47 41 203, on the two weld studs in the wheel housing behind the wheel. Cut the weld studs to a max. length of 11 mm, measured from the body panel. Grind the nuts to a thickness of 8 mm
