PRE-RELEASE
Bonnet
| Bonnet |
| To remove |
| Note | ||
|
It is recommended that 2 people carry out steps 3, 4 and 5. |
| 1. |
Open the bonnet.
|
||||||||||
| 2. |
Remove the washer nozzle hose from the bracket on the cover over the bulkhead.
|
|
| 3. |
Mark the position of the bonnet and release the bonnet from the hinges, (2 persons).
|
|
| 4. |
Detach the gas spring from the bonnet (secured on a ball pin, locked with a clip), (2 persons).
|
|
| 5. |
Lift away the bonnet, (2 persons).
|
|
| To fit |
Fit the bonnet in reverse order.
| Note | ||
|
Bonnet replacement: Remove the front seal and sound insulation (use curved needle-nose pliers) from the bonnet to be replaced and remount these on the new bonnet. |
| Adjustment |
| Note | ||
|
The bonnet hinge mountings are elongated to permit bonnet position adjustment. |
| 1. |
Open the bonnet and loosen the 4 retainer bolts from the bonnet hinges.
|
|
| 2. |
Adjust the bonnet and tighten the retainer bolts.
|
|
After adjustment
| • |
Check the function by opening and closing the bonnet a few times. Drop the bonnet from a height of about 30 cm (12 inches).
|
|
| • |
Check the bonnet locking mechanism by pulling up the front of the closed bonnet.
|
|
| Adjustment of bonnet height |
| • |
Adjust the bonnet height by means of the striker pin, nominal height 62 mm. Adjust the stops accordingly.
|
|
