Bridge spoiler, rear Viggen
|
|
Bridge spoiler, rear Viggen
|
|
1.
|
Remove the wiper arm on the tailgate.
|
|
3.
|
Remove the wiper motor.
|
|
4.
|
Undo the three screws securing the spoiler in place.
|
|
5.
|
Lower the tailgate and remove the four screws at the outer ends of the spoiler and remove the holders.
|
|
6.
|
Close the tailgate carefully and lift the spoiler away.
|
|
7.
|
Remove the four screws holding the spoiler together and separate its upper and lower parts.
|
|
1.
|
If the spoiler has been separated, screw the upper and lower parts together.
|
|
2.
|
Open the tailgate halfway and fit the holders on the ends of the spoiler. Insert the screws.
|
|
3.
|
Check that the spoiler is on straight. It should be parallel with the window's bottom moulding.
|
|
4.
|
Tighten the spoiler's three retaining nuts and the screws in the outer ends of the spoiler.
|
|
5.
|
Fit the wiper motor and plug in the connector. Fit the wiper arm.
|
|
6.
|
Check the operation of the wiper, making sure it has the correct parking position.
|
