PRE-RELEASE
Bumper, front
| Bumper, front |
| Removing |
| 1. |
Raise the car.
|
|
| 2. |
Remove the two spoiler shields.
|
|
| 3. |
Loosen the wing liners from the rear of the bumper.
|
|
| 4. |
Lower the car.
|
|
| 5. |
Open the bonnet.
|
|
| 6. |
Remove the grille.
|
|
| 7. |
Fold out the wiper arms for the headlamps and remove the washer fluid hose, fastened with clips in the bumper.
|
|
| 8. |
Remove the right and left headlamp and combination lamp.
|
|
| 9. |
Remove the two bolts securing the bumper to the body.
|
|
| 10. |
Cut the cable ties holding the leads for the roof lights and unplug the connectors.
|
|
| 11. |
Unplug the temperature sensor connector in the middle of the bumper.
|
|
| 12. |
Remove the bumper by lifting and pulling the bumper forwards so that it goes clear of the attachments in the wing and front.
|
|
| Fitting |
| 1. |
Position the bumper and tighten the two retaining bolts.
Tightening torque: 39 Nm (29 lbf ft). 
|
|
| 2. |
Plug in the connector for the temperature sensor.
|
|
| 3. |
Mount the headlamp washer fluid hose to the bumper, fasten with clips.
|
|
| 4. |
Fit the right and left headlamps and the combination lamp.
|
|
| 5. |
Refit the grille.
|
|
| 6. |
Fold down the headlamp wiper arms.
|
|
| 7. |
Raise the car.
|
|
| 8. |
Carefully fold in the wing liners inside the bumper edge and fasten the wings.
|
|
| 9. |
Refit the spoiler shields.
|
|
| 10. |
Lower the car.
|
|
| 11. |
Close the bonnet and check the bumper fit.
|
|
| 12. |
Check the headlamp alignment and adjust if necessary.
|
|
