PRE-RELEASE
Bumper, rear
| Bumper, rear |
| 1. |
Open the tailgate.
|
|
| 2. |
Remove the door sealing moulding at the lower edge.
|
|
| 3. |
Remove the lashing eyes.
|
|
| 4. |
Fold down the luggage compartment mat.
|
|
| 5. |
Remove the scuff plate by pulling it straight up, it is fastened with clips.
|
|
| 6. |
Undo the nuts securing the bumper.
|
|
| 7. |
Drill out the two blind rivets and remove the plastic moulding securing the front edges of the bumper to the wheel housings.
|
|
| 8. |
Remove the bumper by pulling it rearwards so that it clears the attachments.
|
||||||||||
| Fitting |
| 1. |
Position the bumper on the car and screw on the nuts.
Tightening torque: 39 Nm (29 lbf ft). |
|
| 2. |
Adjust the fit and tighten the retaining nuts.
|
|
| 3. |
Mount the plastic mouldings in the front of the bumper, above the wheel housing edges.
|
|
| 4. |
Fit the scuff plate by pressing it into place and securing it with the clips and then fit the lashing eyes.
|
|
| 5. |
Fold back the mat in the luggage compartment.
|
|
| 6. |
Refit the tailgate weatherstrip moulding.
|
|
| 7. |
Close the tailgate and check the bumper fit.
|
|
