PRE-RELEASE

Cup holder

Cup holder

To remove

Note
This description applies to Saab original equipment. If the car is fitted with a sound system other than Saab standard, the radio code may be required when reconnecting.

Press both special tools into the intended holes in the main unit. Press until the tools click home.

Pull out the main unit with the tools. Remove the tools.

Unplug the connector and antenna cable.

Unplug the DIN connector for the external amplifier if one is connected.

Put the unit to one side.

Press out SID from behind.

Unplug the connector and lay the unit to one side.

Bend in the hooks with a small screwdriver and pull out the cup holder a few millimetres.

Pull out the cartridge with cup holder while pressing down the lugs with a small screwdriver.

To fit

Press in the cartridge with cup holder. Press out the hooks with a small screwdriver.

Plug the connector into the SID unit.

Slide the SID unit into its holder. Take care not to jam the cable.

Important
Make sure the lock tabs on the main unit have not been pressed in too far, as this will prevent the unit fastening securely in the dashboard.

Plug in the connector and the antenna cable to the main unit.

Plug in the DIN connector for the external amplifier if the car is fitted with one.

Slide the main unit into the console until a click is heard.

Check that the cup holder is functioning satisfactorily.

Check the operation of the audio unit and set the time on the clock.