PRE-RELEASE
Floor console
| Floor console |
| 1. |
Apply the handbrake.
|
|
| 2. |
Remove the antenna unit by turning it slightly anticlockwise and then lifting it up.
|
|
| 3. |
Remove the cover plate of the ignition switch by first lifting the rear edge of the cover clear and then disengaging the front edge.
|
|
| 4. |
Undo the retaining screw of the floor console.
|
|
| 5. |
Take out the rear ashtray/cover.
|
|
| 6. |
Remove the rear cover.
|
|
| 7. |
Remove the floor console retaining nuts.
|
|
| 8. |
Loosen the floor console by pulling it straight back and lifting it slightly.
Unplug the connector to the remote control receiver. |
|
| 9. |
Convertible:
Remove the interior lighting switch using a screwdriver or by pressing from below and pulling straight up (the switch is secured with clips). Unplug the switch contact.
|
|
| 10. |
Loosen the window lift module by releasing the front (snap fastener). Unplug the window lift module connector.
|
|
| 11. |
Lift away the floor console.
|
|
| To fit |
| Note | ||
|
The centre console must be fitted before fitting the floor console. |
| 1. |
Fit the floor console over the handbrake. Do not press down the console but leave it loose.
|
|
| 2. |
Feed the window lift and antenna unit connectors (Convertible: interior lighting also) through the applicable holes.
|
|
| 3. |
Plug in the window lift module connector and fit the module.
Convertible: Connect the interior lighting and fit the switch. |
|
| 4. |
Plug in the remote control receiver connector.
|
|
| 5. |
Tighten the floor console retaining screws and nuts.
|
|
| 6. |
Put the rear cover in place, making sure the air duct is connected properly to the air nozzle.
|
|
| 7. |
Screw on the module.
|
|
| 8. |
Fit the ashtray/cover.
|
|
| 9. |
Fit the ignition switch cover.
|
|
| 10. |
Fit the antenna unit.
|
|
