PRE-RELEASE
Rear seat belts, 3D/5D
| Rear seat belts, 3D/5D |
| To remove |
| 1. |
Raise the rear seat, both cushions.
|
|
| 2. |
5-door:
Remove the scuff plates on the right and left-hand rear sills (fastened with clips).
|
|
| 3. |
Remove the seat-belt anchorages on the sides, they are fastened to the side impact protection.
|
|
| 4. |
Remove the centre belt anchorage.
|
|
| 5. |
Remove both the rear head restraints.
|
|
| 6. |
Remove the head restraint mountings from the belt member. Release the catch inside the sleeve with a screwdriver and tap out the mounting from below.
|
|
| 7. |
Undo the centre cover on the belt member, it is fastened with clips.
|
|
| 8. |
Remove the lock handle for the 40% section.
|
|
| 9. |
Remove the right-hand cover and unhook the cable from the lock arm.
|
|
| 10. |
Remove the belt member release handle and undo the cable from the handle.
|
|
| 11. |
Undo the left-hand cover on the belt member.
|
|
| 12. |
Remove the covers from the seat belts.
|
|
| 13. |
Remove the inertia reel retaining bolts.
|
|
| To fit |
| 1. |
Fit the inertia reel retaining bolts.
Tightening torque 38 Nm (28 lbf ft). |
|
| 2. |
Refit the covers onto the seat belts.
|
|
| 3. |
Refit the left-hand cover onto the belt member.
|
|
| 4. |
Fit the cable onto the handle and refit the belt member release handle.
|
|
| 5. |
Hook on the cable to the lock arm and fit the right-hand cover.
|
|
| 6. |
Fit the lock handle to the 40% section.
|
|||||||
| 7. |
Fasten the centre cover to the belt member.
|
|
| 8. |
Fit the head restraint mountings into the belt member.
|
|
| 9. |
Fit both the rear head restraints.
|
|
| 10. |
Fit the centre belt anchorage.
|
|
| 11. |
Fit the side belt anchorages, they are fastened to the side impact protection.
|
|
| 12. |
5-door:
Fit the scuff plates to the right and left-hand rear sills (fastened with clips).
|
|
| 13. |
Lower both the rear seat cushions.
|
|
