Glass hatch (sunroof hatch)
|
|
Glass hatch (sunroof hatch)
|
|
1.
|
Open the sunroof to expose the retaining screws for the cover moulding.
|
|
2.
|
Remove the four retaining screws from the cover moulding.
|
|
4.
|
Remove the rear end of the cover by releasing the clip, one on each side, and pulling towards the centre of the car.
|
|
5.
|
Remove the 6 retaining screws from the glass hatch.
|
|
6.
|
Lift off the glass hatch.
|
|
1.
|
Fit the sunroof hatch in position.
|
|
2.
|
Insert the 6 retaining screws.
|
|
3.
|
Adjust the fit against the roof, one side at a time:
|
|
|
•
|
0 to -1 mm at the front edge
|
|
|
•
|
0 to +1 mm at the rear edge
|
|
4.
|
Tighten the retaining screws.
|
|
5.
|
Open the sunroof hatch slightly so that the cover moulding can be fitted.
|
|
6.
|
Fit the cover moulding, close the hatch and fasten its clips at the outer edge.
|
|
7.
|
Open the hatch slightly and tighten the four retaining screws.
|
