Camshaft cover with gasket
|
|
Camshaft cover with gasket
|
|
1.
|
Remove the upper engine cover.
|
|
2.
|
Unplug the mass air flow sensor connector.
Certain models:
Detach the SAI hose.
All:
Detach the inlet hose and remove the cover from the air cleaner. Take out the filter element.
|
|
3.
|
Detach the fuel pipes from their snap fasteners and remove the bracket bolts from the camshaft cover.
|
|
4.
|
Remove the cover over the ignition coils.
|
|
5.
|
Remove the bolts, lift up each ignition coil and move aside. Start with the ignition coil for cylinder 1.
|
|
6.
|
Detach the crankcase ventilation hose from the camshaft cover.
|
|
7.
|
Undo the cable duct from the cylinder head and camshaft cover and move it carefully aside.
|
|
8.
|
Detach the ground lead from the camshaft cover.
|
|
9.
|
Remove the heat shield over the turbocharger.
|
|
10.
|
Remove the camshaft cover.
|
|
11.
|
Remove the camshaft cover gasket and seals around the spark plug holes.
|
|
1.
|
Fit the camshaft cover with new seals for the bolts. Take care not to disturb the position of the seals when fitting.
Tightening torque 10 Nm (8 lbf ft).
|
|
2.
|
Fit the heat shield over the turbocharger. Make sure the clip under the heat shield snaps onto the holder.
|
|
3.
|
Connect the ground cable to the camshaft cover.
|
|
4.
|
Fit the cable duct on the camshaft cover.
|
|
5.
|
Connect the crankcase ventilation hose to the camshaft cover.
|
|
6.
|
Fit the ignition coils. Start with ignition coil for cylinder 4.
Tightening torque 8 Nm (6 lbf ft).
|
|
7.
|
Fit the cover over the ignition coils.
|
|
8.
|
Fit the bolts for the bracket to the camshaft cover and fit the fuel pipes in their snap fasteners.
|
|
9.
|
Refit the filter element and fit the cover on the air cleaner casing. Plug in the mass air flow sensor connector.
Certain models:
Connect the SAI hose.
|
|
10.
|
Connect the inlet hose.
|
|
11.
|
Fit the upper engine cover.
|
