Unit, steering wheel lock (708)
|
|
Unit, steering wheel lock (708)
|
|
Important
|
|
Cars with VIN LHD -31026543 and RHD -31026620 can be fitted with two alternative steering columns with different gear angles.
|
|
The steering column lock (SCL) with part number 12 789 484 has been discontinued and replaced with a new assembly with number 12 801 116. This means the column integration module (ICM) must be updated to the latest version. 12 801 153 and 12 801 116/12 789 484 are not interchangeable as they are intended for use with different gear angles.
|
|
|
|
Note
|
|
The steering wheel lock must be unlocked for removal. The key must be in the ignition switch in the LOCK position.
|
|
1.
|
Turn the key to LOCK and allow the key remain in the ignition switch.
|
Note
|
|
The steering wheel lock must be unlocked for this procedure.
|
|
|
3.
|
Turn the steering wheel so that the steering shaft joint can be accessed.
Fixate the steering wheel with fabric-backed tape to the instrument panel so as to avoid damaging the contact roller.
|
|
4.
|
Remove the steering shaft joint from the steering shaft.
|
|
6.
|
Tighten the bolt fully to lift off the lock unit.
|
|
1.
|
If refitting the same lock unit:
Unscrew the bolt fully.
Apply
74 96 268 Threadlock
to the bolt and screw this into the lock unit.
|
Important
|
|
Cars with VIN LHD -31026543 and RHD -31026620 can be fitted with two alternative steering columns with different gear angles.
|
|
The steering column lock (SCL) with part number 12 789 484 has been discontinued and replaced with a new assembly with number 12 801 116. This means the column integration module (ICM) must be updated to the latest version. 12 801 153 and 12 801 116/12 789 484 are not interchangeable as they are intended for use with different gear angles.
|
|
|
|
|
2.
|
Position the lock unit and screw out the bolt.
Tightening torque 6 Nm (4,5 lbf ft)
|
|
3.
|
Plug in the connector.
|
|
4.
|
Fit the steering shaft joint to the steering shaft. Clean the threads and apply
74 96 268 Threadlock
to the threads.
Warning
|
|
Make sure the screws fits into the groove in the steering shaft.
|
|
|
|
|
|
Tightening torque 26 Nm (19 lbf ft)
|
|
6.
|
After fitting a new steering wheel lock unit:
Connect the diagnostic tool and program the unit to the car as follows.
|
|
|
6.b.
|
Select
Model Year(s)
|
|
|
6.c.
|
Select
Vehicle Type(s)
|
|
|
6.f.
|
Select
Other Components
|
|
|
6.i.
|
Follow the instructions in the diagnostic tool
|
|
7.
|
Disconnect the diagnostic tool.
|
|
8.
|
Check the function of the steering wheel lock.
|
Note
|
|
When the unit has been disconnected from the voltage supply the car must be driven at a speed of at least 7km/h and then stopped before the function is operative.
|
|
