PRE-RELEASE
Hydraulic body, front, level 1 and 2
| Hydraulic body, front, level 1 and 2 |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Remove the wheel.
|
|
| 3. |
Remove the retaining spring from the brake caliper.
|
|
| 4. |
Press in the piston by prising with a screwdriver against the brake pad.
|
|
| 5. |
Depress the brake pedal slightly using a brake pedal clamp.
|
|
| 6. |
Remove fuse 6 from the instrument panel electrical centre 22.
Instrument panel electrical centre 22 (IPEC)
.
|
|
| 7. |
Detach the brake hose. Plug the hose and the caliper.
|
|
| 8. |
Remove the protective covers and the hydraulic body guide pins and lift off the body.
|
|
| 9. |
Remove the inner brake pad from the body and the outer brake pad from the bracket.
|
|
| To fit |
| 1. |
Place the outer brake pad into the carrier.
Fit the inner brake pad into the hydraulic body. 
|
|
| 2. |
Put in place the hydraulic body and fit the guide pins and protective covers.
Tightening torque 28 Nm (21 lbf ft) 
|
|
| 3. |
Fit the brake hose with new seals.
Tightening torque: 40 Nm (30 lbf ft) |
|
| 4. |
Fit the retaining spring to the brake caliper. Lay the outer contact surfaces against the bracket and push the centre of the clip.
|
|
| 5. |
Remove the brake pedal clamp and refit fuse 6 in the instrument panel electrical centre 22.
|
|
| 6. |
Bleed the brake system
.
|
|
| 7. |
Fit the wheel
.
|
|
| 8. |
Lower the car.
|
|
| 9. |
Depress the brake pedal repeatedly in order to press out the brake pistons.
|
|
| 10. |
Check the brake fluid level and top up as necessary.
|
|
