SAAB WIS ONLINE

PRE-RELEASE

Power steering pump, B207 petrol engine

Power steering pump, B207 petrol engine

Important

Scrupulous cleanliness must always be observed during all work with hydraulic components.


To remove


1. Detach the return hose, wipe up any fluid spill with a cloth and plug the reservoir pipe using 82 92 955 Plugs, spare part kit . Suspend the hose so that fluid does not run out.


2. Cut off the cable tie holding the pressure sensor cable to the delivery pipe. Unplug the pressure sensor's electrical connection.

3. Remove the delivery pipe from the pump. Wipe up any oil spill with a cloth.

4. Remove the pump. Some engine oil may run out.

5. Empty the fluid from the pump.


To fit


1. Fit the pump using a new gasket.

Tightening torque 22 Nm (16 lbf ft)


2. Connect the return hose.


3. Connect the delivery line using new gaskets.

Tightening torque 32 Nm (24 lbf ft)

4. Plug in the pressure sensor's electrical connector and secure the pressure sensor cable to the pipe using a cable tie.

5. Fill with fluid and bleed the power steering system . Check for leaks.


PRE-RELEASE