PRE-RELEASE
Anti-roll bar bush, rear
| Anti-roll bar bush, rear |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Detach the anti-roll bar from the steering swivel members.
|
|
| 3. |
Remove the anti-roll bar mountings from the subframe.
|
|
| 4. |
Remove the bushes from the anti-roll bar.
|
|
| To fit |
| 1. |
Clean the anti-roll bar and grease the inside of the bushes with
30 20 476 Ball bearing grease
. Fit the bushes to the anti-roll bar and fit the caps.
|
|
| 2. |
Fit the anti-roll bar to the subframe.
Tightening torque bolt 8·8 (flange diameter 15.2 mm): 18 Nm (13 lbf ft) and use Thread locking adhesive, Loctite 242 Tightening torque bolt 10·9 (flange diameter 16.7 mm): 31 nm (23 lbf ft) 
|
|
| 3. |
Fit the anti-roll bar link to the steering swivel member on both sides.
Tightening torque 53 Nm (39 lbf ft) |
|
| 4. |
Lower the car to the floor.
|
|
