PRE-RELEASE
(801-2413) Sealing the A-pillar
Symptom: Water leakage on the inside of the A-pillar
| MODIFICATION INSTRUCTION | |
| Bulletin Nbr: | 801-2413 |
| Date: ........... | Juni 2003 |
| Market: | all |
| Sealing the A-pillar |
| Service Campaign 157 14 |
Cars in stock must be rectified before delivery.
Cars already delivered must be rectified in connection with a scheduled visit to the garage for service or repairs.
| Cars affected |
Saab 9-3 (9440) M03, see separate list for Vehicle Identification Number.
| Background |
Improper A-pillar sealing carried out during production may cause water leakage.
Symptom description
Water leakage on the inside of the A-pillar| Parts required |
16 - 30 07 085 Teroson Terostat 1K-PUR (enough for approx. 10 cars)
| Procedure |
The procedure must be performed on both sides. The following method shows the left-hand side; the right-hand side should be completed in a corresponding manner.
| 1. |
Remove the side windscreen moulding.
|
|
| 2. |
Loosen the upper windscreen weatherstrip, approx. 10 cm.
|
|
| 3. |
Mask with tape as shown in the illustration.
|
|
| 4. |
Make sure the area is dry. Apply the sealing compound around the corner, approx. 5 cm on both sides of the corner. Make sure the sealing compound is applied evenly.
|
|||||||
| 5. |
Remove the tape. Clean if necessary.
|
|
| 6. |
Fit the upper windscreen weatherstrip.
|
|
| 7. |
Fit the side windscreen moulding.
|
|
| 8. |
Remove the A-pillar trim.
|
|
| 9. |
Check for leaks as follows:
|
|
| • |
Pour water on the area where the seal has been made.
|
| • |
Check that there is no leakage on the inside of the A-pillar.
|
| 10. |
Fit the A-pillar trim.
|
|
| Time/Warranty information |
See separate information.
