PRE-RELEASE
Lock cylinder
| Lock cylinder |
| Removing |
| 1. |
The window should be closed.
|
|
| 2. |
Remove the
Front door trim, 4D
and fold down the water barrier.
|
|
| 3. |
Cars with guard
: Remove the guard's screws.
|
|
| 4. |
Cars up to and including Vehicle Identification Number 31030983:
Detach the lock cover to the handle rod.
|
|||||||
| 5. |
Cars from and including Vehicle Identification Number 31030984
: Detach the lock cover to the handle rod.
|
|
| 6. |
Loosen the handle's rod from the clip.
|
|
| 7. |
Cars with guard
: Remove the bolts on the lock unit.
|
|
| 8. |
Cars with guard
: Remove the guard by coaxing it out.
|
|
| 9. |
Fit the upper rear nut to the handle and lock cylinder.
|
|
| 10. |
Turn the lock cylinder anticlockwise and pull out the cylinder from the handle.
|
|
| 11. |
Unhook the lock cylinder from the lock rod.
|
|
| Fitting |
| 1. |
Hook the lock cylinder on the rod.
|
|
| 2. |
Fit the lock cylinder by pushing the lock cylinder and turning it clockwise.
|
|
| 3. |
Fit the upper rear nut on the handle and lock cylinder.
|
|
| 4. |
Cars with guard
: Place the guard in the door. Make sure the handle's rod comes in front of the guard. Lift up the cover by the rear edge so that it is placed between the lock cylinder and the window's U-strip.
|
|
| 5. |
Cars with guard
: Insert the lock unit bolts and the guard bolt.
|
|
| 6. |
Cars with guard
: Tighten the bolts.
|
|
| 7. |
Cars up to and including Vehicle Identification Number 31030983:
Fit the rod to the clip. Lift in the clip and hold the rod down at the same time as fitting the lock cover in order to eliminate play.
|
|
| 8. |
Cars from and including Vehicle Identification Number 31030984
: Fit the rod in the clip. Close the lock cover to the clip.
|
|
| 9. |
Check the function of the lock, lock cylinder and the outer handle.
|
|
| 10. |
Fit the water barrier and
door trim
.
|
|
| 11. |
Cars with pinch protection:
Perform
Programming of the pinch protection
.
|
|
