PRE-RELEASE
Rear door handle
| Rear door handle |
| To remove |
| 1. |
The window should be closed.
|
|
| 2. |
Remove the
Door trim, rear
and fold down the water barrier slightly.
|
|
| 3. |
Remove the lock's screws
|
|
| 4. |
Remove the reflector.
|
|
| 5. |
Remove the clips securing the lock cable and wiring harness.
|
|
| 6. |
Cars up to and including Vehicle Identification Number 31030983
: Detach the lock cover to the handle rod.
|
|
| 7. |
Cars from and including Vehicle Identification Number 31030984
: Detach the lock cover to the handle rod.
|
|
| 8. |
Loosen the handle's rod from the clip. Lower the lock unit a little to access the handle's nuts.
|
|
| 9. |
Remove the nuts from the handle. Take care not to drop any of the nuts.
|
|
| 10. |
Lift out the handle by:
|
|
| 10.A. |
Pull out the lower edge of the handle so that the studs release.
|
| 10.B. |
Pull downwards to get out the handle's counterweight.
|
| 10.C. |
Now lift upwards to get the handle's rod out through the hole.
|
| To fit |
| Note | ||
|
Cars up to and including Vehicle Identification Number 31030983 : When replacing with a new clip on the handle rod, the rod must also be replaced in order to fit into the clip. |
| 1. |
Check the handle's gasket so that it is in one piece and located correctly.
|
|
| 2. |
Fit the handle by:
|
|
| 2.A. |
Insert the handle's rod in the door.
|
| 2.B. |
Angle in the handle's counterweight.
|
| 2.C. |
Angle in the handle's lower edge and insert the studs in the holes.
|
| 3. |
Fit the handle's nuts.
|
|
| 4. |
Position the lock. Fit the lock's screws.
|
|
| 5. |
Cars up to and including Vehicle Identification Number 31030983
: Fit the rod to the clip. Lift in the clip and hold the rod down at the same time as fitting the lock cover in order to eliminate play.
|
|
| 6. |
Cars from and including Vehicle Identification Number 31030984:
Fit the rod in the clip. Close the lock cover to the clip.
|
|
| 7. |
Fit the cable harness's and lock wire's clips
|
|
| 8. |
Check the function of the handle.
|
|
| 9. |
Fit the reflector.
|
|
| 10. |
Fit the water barrier and
door trim
.
|
|
| 11. |
Cars with pinch protection:
Perform
Programming of the pinch protection
.
|
|
