PRE-RELEASE
Rear widow lift
| Rear widow lift |
| To remove |
| 1. |
Open the window about 10 cm and fasten it with tape.
|
|
| 2. |
Remove the door trim and water barrier.
|
|
| 3. |
Slacken/remove the bolts to release the window.
|
|
| 4. |
Remove the window lift nuts and bolt.
|
|
| 5. |
Press out the window lift so that the studs comes loose from the mounting holes.
|
|
| 6. |
Unplug the motor connector.
|
|
| 7. |
Extract the rail at an angle through the opening.
|
|
| To fit |
| Note | ||
|
Cars with pinch protection : If the window lift is replaced with M04- then the door control module must also be from M04-. |
||
|
To distinguish the window lift from M03 and M04-, check the colour of the pulley behind the window lift motor. |
||
|
M03 = White |
||
|
M04 = Light brown/beige |
||
|
Check the above in order to avoid the pinch protection incorrectly deploying. |
||
|
The pinch protection can be deactivated using Tech 2 (version 127.000 or later) under the menu, Fault diagnosis - Model year 2003 - Saab 9-3 Sport (9440) - All - Service - Activate/Deactivate pinch protection. |
||
|
This deactivation means that the "Express up" function is deactivated. |
| 1. |
Insert the rail at an angle and fit the studs into the mounting holes.
|
|
| 2. |
Fit the nuts and bolt.
|
|
| 3. |
Plug in the connector.
|
|
| 4. |
Remove the tape.
|
|
| 5. |
Lower the window to its mountings. Press the window down into the rubber lined mountings.
|
|
| 6. |
Tighten the window screws.
|
|
| 7. |
Raise and lower the window a few times to check its operation.
|
|
| 8. |
Fit the water barrier and the door trim.
Cars with pinch protection : Perform Calibration of pinch protection |
|
