PRE-RELEASE
Rear silencer
| Rear silencer |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Cut the exhaust pipe to the specified dimension. Cut the pipe at right angles. Use
83 95 667 Pipe cutter/exhaust system
.
|
|
| 3. |
Remove the rear silencer.
|
|
| To fit |
| 1. |
Clean the cut to remove burrs and dirt.
|
|
| 2. |
Fit a sleeve clamp to the pipe.
|
|
| 3. |
Fit the rear silencer with new rubber mountings.
|
|
| 4. |
If necessary, change also the rubber mountings suspending the front silencer.
|
|
| 5. |
Adjust the sleeve clamp so that the pipe ends are in the centre of the clamp.
|
|
| 6. |
Adjust the front and rear silencers so they hang evenly.
|
|
| 7. |
Tighten the nuts on the clamp.
Tightening torque Nm ( lbf ft). |
|
| 8. |
Lower the car.
|
|
| 9. |
Connect an exhaust hose and start the engine. Check the exhaust system for leaks.
|
|
