PRE-RELEASE
Fuel regulator lambda sensor, removing and fitting
| Fuel regulator lambda sensor, removing and fitting |
| To remove |
Caution
Remove the lambda sensor only on a warm engine.
| 1. |
Remove the engine protection cover.
|
|
| 2. |
Undo the cable set connector for the fuel regulator lambda sensor (1) and remove the cable set from the holder.
|
|
| 3. |
Remove the fuel regulator lambda sensor (2) from the exhaust manifold using KM-6129 (
83 96 350 Oxygen sensor dismantling sleeve)
).
|
|
| To fit |
Caution
Moisten the lambda sensor threads with special grease (black) when reusing the fuel regulator lambda sensor.
| 1. |
Fit the fuel regulator lambda sensor into the exhaust pipe with KM-6129
(83 96 350 Oxygen sensor dismantling sleeve
) - tightening torque 30 Nm.
|
|
| 2. |
Connect the cable set connector for the fuel regulation lambda sensor - fasten the cable set.
|
|
| 3. |
Fit the engine cover.
|
|
